QUOTE (fsa @ 30.08.2018, 07:47 Uhr)
hello d-glaser
i am also stuck in same condition just like you ..more then 4 days spend to connect TNCREMO to my machine but no success. i have Grundig millplus DMU80T. and unfortunately still can not find CDSLITE download link ...looking some support to resolve my issue ..
regards
asif
Hey.
I found a solution for my problem. I set up a virtual machine and installed Windows XP on it. Next I installed CDSLite 4.10 on the virtual machine. I configured the connection settings via ethernet in CDSLite and could connect to the MillPlus immidiately.
Download for CDSLite 4.10:
https://de.industryarena.com/forum/index.ph...s&showcat=2(Important: CDSLite Versions prior to 4.10 do not support connection via ethernet!)
According to Heidenhain Support the MillPlus can't connect via TNCremo because the program uses a connection protocol that is not supported by the MillPlus.
Hope that helps.