Bräuchte mal Hilfe, Keine Spindelrichtung an gegeben Finde den Fehler

N1 WORKPIECE(,,,"CYLINDER",0,3,-120,-100,90)
N11 T="SCHRUPPER"
N21 G96 S230 LIMS=3000 M4 M8
N31 G0 X94 Z0 F0.2
N41 G1 X-1.6 F0.2
N51 CYCLE62("KONTUR",0,,)
N61 CYCLE952("Kontur1",,"",1101311,0.1,0.1,0,1,0.1,0.1,0.1,0.1,0.1,0,1,0,0,,,,,2,2,,,0,1,,0,12,110001
0,1,0)
N71 T="FINISHING_T35 A"
N81 G96 S230 LIMS=3000 M4 M8
N91 CYCLE952("Kontur2",,"",1101321,0.1,0.1,0,1,0.1,0.1,0.1,0.1,0.1,0,1,0,0,,,,,2,2,,,0,1,,0,12,110001
0,1,0)
N101 T="THREADING_1.5"
N111 G96 S160 LIMS=3000 M3 M8
N121 G90 G54 G18 G0 X44 Z5
N131 CYCLE99(0,48,-20,,5,3,1.238,0,30,0,5,0,2,1110101,4,2,0.3,0.5,0,0,1,0,0.71476,1,,,,2,1)
N141 G0 X54
N151 G94 G90 G64 G54
N161 G18
N171 SPOS=0
N181 T="FRAESER"
N191 SETMS (2)
N201 S2=1000 M2=3 M8
N211 TRANSMIT
N221 DIAMOF
N231 G0 G17 X10 Y0 Z7
N241 POCKET3(2,0,1,-5,23,23,4,0,0,0,5,0,0,200,80,0,11,2,8,3,15,0,2,0,1,2,11100,11,100)
N251 TRAFOOF
N261 DIAMON
N271 G0 Z2
N281 SETMS (1)
N291 G94 G90 G64 G54
N301 G18
N311 SPOS=0
N321 T="BOHRER_6"
N331 SETMS (2)
N341 S1000 M3
N351 TRANSMIT
N361 DIAMOF
N371 G0 G17 X10 Y0
N381 G0 Z2
N391 F140
N401 MCALL CYCLE82(100,6,1,,25,0.6,10,1,11)
N411 HOLES2(0,0,16,30,30,4,1010,0,,,1)
N421 MCALL
N431 TRAFOOF
N441 DIAMON
N451 G0 Z2
N461 SETMS (1)
N471 M30

Ich glaube ich weiß wer sich bei diesem Thread gleich wieder sehr freuen wird.

Habe das Problem Gefunden N81 G96 S230 LIMS=3000 M4 M8
habe es einfach so Probiert und tada es hat geklappt aber ob es auch so richtig ist weiß ich auch nicht hmm.