[saridev]

Some machining toolpaths include to "cut link distance". Please send me information about "cut link distance" function on worknc. How was "cut link function" works?

Sincerely
Kenan

[Frankenstein]

The principal use of the Cut Link Distance parameter is to reduce the number of retracts by allowing the cutting feed rate to be continued over a distance where, without this parameter, WorkNC would normally perform a retract.

That means: each distance closer than the programed value will be done in cut feedrate instead of making a possible retract.

[saridev]

The principal use of the Cut Link Distance parameter is to reduce the number of retracts by allowing the cutting feed rate to be continued over a distance where, without this parameter, WorkNC would normally perform a retract.

That means: each distance closer than the programed value will be done in cut feedrate instead of making a possible retract.

Thanks again